MagSafe Stand STL Guide

MagSafe Stand STL Guide

Thank you for your MagSafe Mount STL purchase! Specifically designed to hold Apple's official MagSafe Charger, this mount provides a convenient and stylish way to keep your phone charged and ready to go. 

The following is required to use this STL:
Apple MagSafe Charger on Amazon

Optional adhesive pads can be used to stick this MagSafe Mount to your desk and keep the MagSafe charger fixed in place.

There are four files included with your MagSafe STL Pack (10 files if you purchased the four design bundle). 

This is a two part design so you will find an STL file for the top plate along with the base. Each STL also has their own .3mf file which contains all settings, including AMS multicolor setup for Bambu Labs printers. (Note .3mf files have been tested on a Bambu X1C, your results may vary with different printers and filaments).

Print Settings

Here are the settings used to print the top plate and the base, as tested on a Bambu X1C using a 0.4mm nozzle and a 0.2mm layer height.

Filaments used and pictured on our website include PolyTerra Matte PLA & Bambu Matte PLA.

Top Plate (3DP-MAG01-XXXX)

  • No supports required
  • Iron all top surfaces
  • 15% Infill (increase for more weight)
  • Use AMS for multicolor prints

(Bambu Ironing Settings: Rectilinear, 60mm/s speed, 21% flow, 0.15mm line spacing)

Base (3DP-MAG01-BASE)

  • Supports required for adhesive pad cutouts
  • 50% infill (increase for more weight)

Back to blog